The Mono returns with a vengeance.

Replacing the Zero.3 comes with a great responsibility, nevertheless the B2 audio Mono is back and stronger than ever. 2″ narrower than it’s predecessor, it is a perfect hideaway amplifier without the lack of any performance.The revised pcb is upgraded for better low voltage operation, but without compromising the performance at 16v.

With more than 2500 watts at your disposal easily adjusted by the included bass remote with clipping indicator, the Mono has oversized 0 Gauge power terminals which along with the speaker terminals have backlit red LED’s. It is almost a shame not to show off this workhorse that will power any of our subwoofers with dynamic authority.

In case you should need more power, the Mono has both the ability to strap with another Mono for twice the power (Slave 1). Should that not be enough, you can run several Mono’s in a chain (Slave 2), where all settings are controlled by the master amplifier, now that’s Sweet Like Danish. In addition the new crossover setting functions were derived from the legendary class A/B Duo, so now you are able to pin point the exact Hz setting on your amplifers boost, lpf etc. With 41 clicks, each corresponding to a frequency there’s no need to be guessing or investing in tools to acheive the perfect settings of your amplifier.

Manual
SPECIFICATIONS
Frequency Response:15 Hz ~ 250 Hz
Signal to Noise Ratio: 100 dB
Input Sensitivity:6 ~ 0.2 V
Crossover: 24 dB / Oct
Low Pass Crossover: 35 Hz ~ 250 Hz
Subsonic Crossover:35 Hz
Bass Boost: 0 ~ 9 dB
Bass Boost Frequency: 35 Hz ~ 100 Hz
Damping Factor:>300
Power Terminal gauge:
0 GA x 1
Fuse Rating:150 A
Operational voltage:9 V ~ 16 V
Dimensions:13.38" x 9.84" x 2.52"
34 x 25 x 6.4 cm
Power @ 4 Ω 12v:
Power @ 4 Ω 14.4v:
Power @ 4 Ω 16v:		300 w
600 w
700 w
Power @ 2 Ω 12v:
Power @ 2 Ω 14.4v:
Power @ 2 Ω 16v:		 600 w
1200 w
1400 w
Power @ 1 Ω 12v:
Power @ 1 Ω 14.4v:
Power @ 1 Ω 16v:		1200 w
1500 w
2200 w
*In order to get the full power output of the amplifier, it is crucial that your electical system is correctly (over) dimensioned. Failure to upgrading will constrain the power output & lower the efficiency which can cause damage to the amplifier & void the warranty, this also includes ohm loads below of what is written in the manual. Do take your time and read the manual thoroughly before installing!